User's Manual

Wireless LAN Networking

Access Point Manager

When Access Point Manager (APM) is installed on a computer in the network,

you can change all operating parameters of the Access Point. The APM enables

you to configure and monitor the operational performance of your network.

You can install the APM on as many computers in your network as you want,

either wired or wireless. The choice for a wireless or wired computer depends on

your preferences and your network configuration.

Verifying the TCP/IP Protocol Settings

Any computer you install the APM on must have TCP/IP networking protocol

installed to be able to communicate with the Access Point. Using Windows

Control Panel, double-click Network and check that TCP/IP is installed. If

TCP/IP is not installed, install it (refer to TCP/IP Addressing on page 10 for a

proper IP addressing).

All Access Points are

shipped with a factory-

set IP Address of

192.168.1.1 to allow

your APM computer to

communicate with new

Access Points.