User's Manual

11
From the previous figure, you can know that the transmission of
the HG520s and the DSLAM is based on the Asynchronous Transfer
Mode (ATM). To realize all the service modes of the HG520s, configure
the relevant parameters of the HG520s. For example, configure the
Permanent Virtual Channel (PVC) parameter and others.
3.1.2 Steps
The service modes of HG520s can be realized by configuring the
corresponding working parameters.
The steps to realize a service mode are described below.
Step To... Do...
1
Establish the
configuration
environment
Refer to 2.3 "Establishing Configuration
Environment".
2
Configure the
HG520s
(1) Select the PVC to be configured.
(2) Select the service mode of this PVC and
configure the working parameters of the
PVC.
(3) Configure functions according to the
requirement.
For example, configure the DHCP function.
(4) Save the configuration and reboot the
HG520s.
3
Configure your
computer
Configure the working parameters of the
computer NIC or install the dial-up software in the
computer according to the service mode of the
HG520s.
Note:
NIC = Network Interface Card
DHCP = Dynamic Host Configuration Protocol