User Manual
Table Of Contents
ADSL Router User Manual
4
6. Connect the supplied power adapter to the PWR port of your ADSL Router, and plug the other end to a power
outlet.
7. Turn on the power switch.
Note:
For Full Rate (G.dmt) standard, a POTS Splitter is necessary on subscriber’s premise to keep the
telephone and ADSL signals separated, giving them the capability to provide simultaneous
Internet access and telephone service on the same line. To connect a POTS Splitter:
1. Connect the port Phone to your telephone.
2. Connect the port Modem to your ADSL Router.
3. Connect the port Line to the ADSL wall jack.
USB Driver Installation
If the ADSL Router is connected to a PC through USB interface, you will be prompted for the USB drivers when
plugging the USB cable to the PC. Refer to the relevant operating system to install the USB drivers. Otherwise, you
may skip this chapter.
F
F
o
o
r
r
W
W
i
i
n
n
d
d
o
o
w
w
s
s
9
9
8
8
Step 1 When plugging the USB cable to the PC, the system will automatically detect the USB ADSL Router.
When Add New Hardware Wizard window announces detecting of the USB device, click Next.
Note: If the USB device is not detected, check the USB cable between the PC and the
device. Also verify that the device is power on.
Step 2 When prompted for driver files, select Search for the best driver… and click Next.