User's Manual

User Guide ADSL Router (RTA1435VW)
5.5 Establishing a WAN Ethernet Session using VersaPort™2
Important: Before you set up a connection profile, an Account ID and Account Password may be required from
your Internet service provider. You will use this information when you set up your account parameters. If you are at
a screen and need help, click the Help link located at the right of the screen.
After you have confirmed your DSL sync, click on the Advanced tab. Hold the mouse over WAN and select
VersaPort to set up your connection profile.
1.
2.
3.
Click the radius button next to Ethernet WAN uplink to configure the router for an Ethernet connection.
Select the Protocol as assigned by the Internet Service Provider. This will be either PPPoE or Routed IP.
If PPPoE is selected, you will be required to enter an Account ID and Account Password as
described in section 5.3. This will be provided by the Internet Service Provider (ISP).
If Routed IP is selected you may be required to enter IP Address information.
If IP Address information was provided by the ISP, enter the information as seen below.
530-300547 Rev. 2 18 January 2008
ADSL Router (RTA1435VW-D27)