User's Manual

117
10. RIPDefaultGateway: Gateway IP for RIPIP
11. On/Off: Enable or disable this item rule.
12. When done, click Apply.
3.2.3 Multiple NAT
This can let you limit range of ipaddress that is going to use NAT function.
Steps to set Multiple NAT:
1. From the navigation panel, go to Root > Router > Multiple NAT.
2. Enable Multiple NAT: Check [Yes] to enable this function, Check [No] to
disable this function.
3. Name: The name for the item bar.
4. Public IP: IP address that Host IP will be mapped to.
5. Network/Host IP: IP address of the host reside on lan-side.
6. Subnet Mask: The subnet mask for lan-side IP address.
7. On/Off: Enable or disable the multiple NAT rule.
8. Click to add this item to the Multiple NAT List.
9. Click Apply.