User Manual

Chapter 2: WEB Configuration
Illustrations contained in this document are for representation only.
59
Automatic Security Configuration
Fig. 38 Automatic Security Configuration
WiFi Protected Setup (WPS) is an easy and secure way of configuring and connecting your WiFi access point.
In your case, the DWG875/DWG875T is the Access Point (AP), and Your PC (or Wifi Device) is called the
STA. When configuring your Wifi Network via WPS, Messages are exchanged between the STA and AP in
order to configure the Security Settings on both devices.
 WPS Config: It will help you to Enable or Disable the WPS feature. To enable you need to select WPS,
to disable you need to select Disabled.
Note: After you Enabled the WPS you will get the options as show in Fig.35 and the WPS Config State
box will show its configuration status.
 Device Name: By using this you can change the factory default to a name of your choice which is up to 32
characters long as like SSID.
 WPS Setup AP: Here you do not need to change anything, just skip this step.
 WPS Add Client: T here are two methods “Push-Button” and “PIN”. Select the method you want.
But, the default selection will be “PIN”.