User's Manual
Table Of Contents
- WebSTAR™ DPC2223™ and EPC2223™ VoIP Cable Modem with DECT Base Station User’s Guide Introduction
- Notice for CATV Installers
- In This Guide
- IMPORTANT SAFETY INSTRUCTIONS
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where Is the Best Location for My Cable Modem?
- What Are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- What Are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What Are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- Troubleshooting My Internet Service Installation
- How Do I Use My Modem for Telephone Service?
- Where Do I Place My Modem for Telephone Service?
- What Are the Requirements for Telephone Service?
- How Do I Install the Modem for Telephone Service?
- How Do I Maintain the Battery? (Optional Model only)
- How Do I Mount the Cable Modem on a Wall? (Optional)
- Telephone Service Frequently Asked Questions
- Having Difficulty?
- Tips for Improved Performance
- Front Panel LED Status Indicator Functions
- Notices
- FCC Compliance
- For Information
WebSTAR DPC2223 and EPC2223 VoIP Cable Modem User’s Guide Preliminary Draft 02 – 1/26/06
50
FCC Privacy Statement
Privacy of communications may not be ensured when using this phone.
FCC Part 68
The Federal Communications Commission (FCC) of the United States restricts
specific uses of modems, and places registration responsibilities on both the
manufacturer and the individual user.
1. The modem may not be connected to a party line or to a coin-operated
telephone.
2. The modem manufacturer must make any repairs to the modem to
maintain valid FCC registration.
3. Notification to the telephone company is no longer required prior to
connecting registered equipment, but upon request from the telephone
company, the user shall tell the telephone company which line the
equipment is connected to as well as the registration number and ringer
equivalence number of the registered protective circuitry. FCC
information is printed on a label on the bottom of the modem.
IC (Industry Canada) Notice
Notice: The Industry Canada (formerly Canadian Department of
Communications) label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective,
operational, and safety requirements. The department does not guarantee the
equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring associated with a single-line individual
service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made
by the user may give the telecommunications company cause to request the user
to disconnect the equipment. Users should ensure for their own protection that
the electrical ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together. This precaution
may be particularly important in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or
electrician, as appropriate.