User's Manual
Table Of Contents
- WebSTAR™ DPC2223™ and EPC2223™ VoIP Cable Modem with DECT Base Station User’s Guide Introduction
- Notice for CATV Installers
- In This Guide
- IMPORTANT SAFETY INSTRUCTIONS
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where Is the Best Location for My Cable Modem?
- What Are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- What Are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What Are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- Troubleshooting My Internet Service Installation
- How Do I Use My Modem for Telephone Service?
- Where Do I Place My Modem for Telephone Service?
- What Are the Requirements for Telephone Service?
- How Do I Install the Modem for Telephone Service?
- How Do I Maintain the Battery? (Optional Model only)
- How Do I Mount the Cable Modem on a Wall? (Optional)
- Telephone Service Frequently Asked Questions
- Having Difficulty?
- Tips for Improved Performance
- Front Panel LED Status Indicator Functions
- Notices
- FCC Compliance
- For Information
How Do I Mount the Cable Modem on a Wall? (Optional)
41
Mounting the Cable Modem on a Wall
To mount the cable modem on a wall
Complete these steps to mount the cable modem on the wall.
1. Using a drill with a 3/16-in. bit, drill two holes in the wall as follows:
• To mount the cable modem vertically, drill the holes at the same height
and 4 inches apart.
• To mount the cable modem horizontally, drill the holes at the same
height and 4 inches apart.
Note: The graphic on the preceding page illustrates the location of the
mounting holes on the back of the cable modem.
2. Are you mounting the cable modem into a drywall or concrete surface where
a wooden stud is available?
• If yes, go to step 3.
• If no, drive the anchor bolts into the wall, and install the mounting screws
into the anchor bolts leaving a gap of about 1/4-in. between the screw
head and the wall. Then, go to step 4.
3. Install the mounting screws into the wall leaving a gap of about 1/4-in.
between the screw head and the wall. Then, go to step 4.
4. Verify that no cables or wires are connected to the cable modem.
5. Lift the cable modem into position. Slip the large end of both mounting slots
(located in the back of the cable modem) over the mounting screws, then
slide the cable modem down until the narrow end of the keyhole slot contacts
the screw shaft.
Important: Verify that the mounting screws securely support the cable
modem before you release the unit.