User's Manual
Table Of Contents
- WebSTAR™ DPC2223™ and EPC2223™ VoIP Cable Modem with DECT Base Station User’s Guide Introduction
- Notice for CATV Installers
- In This Guide
- IMPORTANT SAFETY INSTRUCTIONS
- What’s In the Carton?
- Front Panel Description
- Back Panel Description
- Where Is the Best Location for My Cable Modem?
- What Are the System Requirements for Internet Service?
- How Do I Set Up My High-Speed Internet Access Account?
- How Do I Connect My Devices to Use the Internet?
- How Do I Configure TCP/IP Protocol?
- How Do I Install USB Drivers?
- What Are the Requirements for Ethernet Network Devices?
- How Do I Select and Place Ethernet Network Devices?
- How Do I Connect Ethernet Network Devices?
- What Are the Requirements for USB Network Devices?
- How Do I Select and Place USB Network Devices?
- How Do I Connect USB Network Devices?
- Troubleshooting My Internet Service Installation
- How Do I Use My Modem for Telephone Service?
- Where Do I Place My Modem for Telephone Service?
- What Are the Requirements for Telephone Service?
- How Do I Install the Modem for Telephone Service?
- How Do I Maintain the Battery? (Optional Model only)
- How Do I Mount the Cable Modem on a Wall? (Optional)
- Telephone Service Frequently Asked Questions
- Having Difficulty?
- Tips for Improved Performance
- Front Panel LED Status Indicator Functions
- Notices
- FCC Compliance
- For Information
WebSTAR DPC2223 and EPC2223 VoIP Cable Modem User’s Guide Preliminary Draft 02 – 1/26/06
38
4. Insert a new battery into the battery compartment.
5. Close the battery compartment door. The battery lock will automatically re-
engage.
Important: It may take as long as 24 hours for the battery to charge fully.
Note: Dispose of the battery in accordance with local regulations and
instructions from your service provider.