User's Manual

Chapter 3: Connections and setup
10
Illustrationscontainedinthisdocumentareforrepresentationonly.
ActivatingtheEMTA
AfteryouinstalltheEMTAandturnitonforthefirsttime(andeachtimethemodemisreconnectedto
thepower),itgoesthroughseveralstepsbeforeitcanbeused.Eachofthesestepsisrepresentedbya
differentpatternofflashinglightsonthefrontofthemodem.
Note:Allindicatorsflashoncepriortotheinitialization sequence.
Ifallofthelightsareflashingsequentially,itmeanstheEMTAisautomaticallyupdatingitssystem
software.Pleasewaitforthelightstostopflashing.Youcannotuseyourmodemduringthistime.Do
notremovethepowersupplyorresettheEMTAduringthisprocess.

TomakesurethatyoucanaccesstheInternetsuccessfully,pleasecheckthefollowingfirst.
1. Makesuretheconnection(throughEthernet)betweentheEMTAandyourcomputerisOK.
2. MakesuretheTCP/IPprotocolissetproperly.
3. SubscribetoaCableCompany.
