User's Manual

Left LED blinks in red indicating low and risk battery and stating red indicating
that the battery is charging. the LED becomes green when battery is fully
charged, then.
 Power On TN450A1
Press and release the power button
Note:
Device turns to the modes as below by pressing power button key.
Suspend Mode
Press and release the power button to place the TN450A1 in suspend mode. In suspend mode
the device turns off the display and goes into a low power state to conserve battery power.
Power Off
To Power off the TN450A1, press and hold the button until the device option dialog box appears,
choose “Power off”. When the Power off dialog box appears, tap “OK”.
Reset
Reset the TN450A1 if application stop responding. Press and hold the power button until the
device options dialog box appears then touch Reset.
Hardware Reset
If the TN450A1 stop responding, perform a hardware reset by long press power button.
Data Capture
 Scan a Bar Code with Imager
1. Switch on the barcode
Go to “Settings” find Barcode Scan Slide Barcode Scan to “ON”