User's Manual

ManualsBrandsAskey Computer ManualsComputers & AccessoriesHome Lan Modem

ASKEY COMPUTER CORP.

SUBJECT : Product Specification

MODEL : HNH010-D75

REV : 02

RL DATE : AUG-11-1999

PAGES : 6

CONTENTS :

Prepared By :

Reviewed By :

Approval By :

Summary of content (6 pages)

PAGE 1
ASKEY COMPUTER CORP.
PAGE 2
TABLE OF CONTENTS Introduction Product Specification Function Requirement - Home LAN Communication - Data Communication - Fax communication - Diagnostics Capabilities - Modem Operational Characteristics - Operating System - Compatibility Requirement - Customer Requirements Interface Specification - DTE Interface - Telephone Network Interface - Power Management Interface Product Reliability Operating Environment Mechanical Characteristics - Dimensions - Flammability Regulatory Standard Compliance
PAGE 3
Introduction The specification defines the product requirement for the HNH010-D75 modem module. The modem is a Home LAN + Controller-less design using Conexant RS7112/RHP56LD chipset for PCI interface that provides HomePNA, Data and Fax communication features described as following: Product Specification Function Requirement - Home LAN Communication * Protocols : HomePNA 1.0 Specification * Data Speed : 1Mbps data rate * AFE type: Integrated AFE - Data Communication * Protocols : V.90, V.34, V.32bis, V.
PAGE 4
- Modem operational Characteristics Under FCC Spec. * Transmit Level : less than -11 dbm +/- 2 dBm W/O AGC * Receive sensitivity : -35 dBm +/- 2 dBm Under V.34 mode * Guard Tone : 550 or 1800 Hz +/- 20 Hz * Answer Tone : CCITT 2100 Hz +/- 15 Hz * Bell 2225 Hz +/- 10 Hz * Dialing Method Under FCC: 1) Tone dialing (A) Symbols : 1 2 3 4 5 6 7 8 9 0 # * A B C D (B) Frequency : within +/- 1.
PAGE 5
Interface Specification - DTE interface The modem provides PCI bus as following definition. *PCI SIG Specification 2.2 *PCI SIG Specification 2.1 *Meets PC99 Requirements *5V and VAUX power Auto switch - Telephone Network Interface The RJ-11C type telephone jack. - Power Management Interface *ACPI power management meets PC99 *PCI SIG Power Management Specification 1.1A *D3 cold function supports *Supports PME signal to wake up the system when Receives ring signal.
PAGE 6
Mechanical Characteristics - Dimensions The modem assembly consists of one 2 layer PCB assembly. The modem is approximately 68.5mm x 145mm. - Assembly The polymeric materials used in the modem assembly meet of exceed the requirement of UL 94.