User Manual

Chapter 1: Connections and Setup

Illustrations contained in this document are for representation only.

Rear Panel

TEL1 & TEL2 Telephony RJ-11 connector

ETHERNET 1-4: Ethernet 10/100BaseT RJ-45 connector

REBOOT EMTA: Reboot this Residential Voice Gateway

CABLE: F-Connector

15VDC: Power connector

Installing the Battery

This section provides information on installing batteries into the modem. Follow the steps below:

1. Ensure the power cord is unplugged.

2. Remove the battery cover on the rear panel. There are two battery compartments. You may install

a single battery into either compartment.