User Manual

Chapter 2: Web Configuration

Enter the MAC addresses of the connected clients into the fields, and then click Apply to add them

to the list for access control.

Apply: After proper configuration, click Apply to invoke the settings.

Connected Clients: The information of currently connected clients will be displayed here.

4. Advanced

This page allows you to configure some advanced settings. The factory default values should provide

good results in most cases. We don’t recommend you change these settings unless you have technical

knowledge of 802.11b wireless technology.

For expert users, details of all settings on this web page are provided below.

Fig. 42

Beacon Interval:

Set the period of beacon transmissions to allow mobile stations to locate and identify a BSS. The

measure unit is “time units” (TU) of 1024 microseconds. (Value range: 1~65535)

DTIM Interval:

The value you set here is used to inform mobile stations when multicast frames that have been buffered

at the Wireless Gateway will be delivered and how often that delivery occurs. (Value range: 1~255)

Fragmentation Threshold:

Set the number of the fragmenting frames to make the data to be delivered without errors induced by the

interference. Frames longer than the value you set here are fragmented before the initial transmission

Illustrations contained in this document are for representation only.