User Manual

Chapter 2: Web Configuration
51
3. Access Control
This page allows you to make access control to the AP or connected clients by offering the MAC
Addresses of the clients.
Fig. 41
Administration Web page Access: It Allow or Deny access to Administration Web Page from PC
connected over WiFi.
Wireless Interface: By default it will be having two interfaces, “Primary Network interface” and
“Guest Network Interface”. The “Primary Network interface” will be available for all users. If you
want to access the “Guest Network Interface” then you need to contact cable operator.
MAC Restrict Mode: Click Disabled to welcome all of the clients on the network; select Allow to
permit only the clients on the list to access the cable modem; or choose Deny to prevent the clients
on the list to access this device.
MAC Address: Your Gateway identifies wireless PCs by their WiFi MAC Address. This address
consists of a string of 6 pairs of numbers 0-9 and letters A-F, such as 00 90 4B F0 FF 50. It is
usually printed on the WiFi card of the device (e.g. the PCMCIA card in a laptop). It can also be
determined from a Windows DOS prompt as explained below.
Illustrations contained in this document are for representation only.