User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 1: Connections and Setup
Illustrations contained in this document are for representation only. 3
Computer Requirements
For the best possible performance from your Digital Cable Modem, your personal computer must
meet the following minimum system requirements (note that the minimum requirements may
vary by cable companies):
IBM PC COMPATIBLE MACINTOSH**
CPU Pentium preferred PowerPC or higher
System RAM 16MB (32MB preferred) 24MB (32MB preferred)
Operating System Windows* NT/2000/Me/XP,
Linux
Mac OS** 7.6.1 or higher
Available Disk Space 125MB 50MB
Sound Card Required for audio on CD-ROM N/A
Video VGA or better (SVGA preferred) VGA or better (SVGA built-in preferred)
CD-ROM Drive Required Required
10BaseT or 100BaseT 10BaseT or 100BaseT Ethernet
An Ethernet card makes it possible for your computer to pass data to
and from the internet. You must have an Ethernet card and software
drivers installed in your computer. You will also need a standard
Ethernet cable to connect the Ethernet card to your EMTA Gateway.
USB (Windows 2000/ME/XP only)
USB Port
The Universal Serial Bus is a high speed bus that enables your
computer to communicate simultaneously with a variety of
peripherals. However, if you have other peripherals that send and
receive a lot of information, such as speakers, printers or scanners, we
recommend using an Ethernet card to support this modem.
*Windows is a trademark of Microsoft Corporation.
**Macintosh and the Mac OS are trademarks of Apple Computer, Inc.
Setting the Modem in the Stand
Once you have the rubber pads attached to the bottom of the stand, place the EMTA Gateway
upright in the stand, making sure to line up the notch of the stand with the groove on the bottom
of the modem.