User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 2: Web Configuration
Illustrations contained in this document are for representation only. 37
than the threshold that you set here will be sent with the four-way frame exchange. And, a
length less than or equal to the value that you set will not be proceeded by RTS.
Bridging
This page allows you to configure the WDS features.
WDS (Wireless Distribution System) is a system that enables the interconnection of access points
wirelessly. It may also be referred to as repeater mode because it appears to bridge and accept
wireless clients at the same time (unlike traditional bridging).
Wireless Bridging:
Choose Disabled to shutdown this function; select Enabled to act as a repeater.
Remote Bridges:
Enter the MAC Addresses of the remote Bridges to relay the signals for each other.