User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 2: Web Configuration
Illustrations contained in this document are for representation only. 35
MAC Restrict Mode:
Click Disabled to welcome all of the clients on the network; select Allow to permit only the
clients on the list to access the cable modem; or choose Deny to prevent the clients on the
list to access this device.
MAC Address:
Enter the MAC addresses of the connected clients into the fields, then click Apply to add
them to the list for access control.
Connected Clients:
The information of current connected clients will be displayed in this field.