User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 2: Web Configuration
30
Password Change User ID: Key in the user ID in this field.
New Password: Enter the new password in this box.
Re-Enter New Password: Enter the new password again for confirmation.
Current User ID Password: Key in the original password.
Restore Factory Defaults: If you want to restore the factory settings, click Yes and Apply.
If not, click No and Apply.
Diagnostics
This page offers basic diagnostic tools for you to utilize when connectivity problems
occur. You may use the ping diagnostics or traceroute, just enter the information needed
and press Start Test; the Result will be displayed in the lower part of the window. Press
Abort Test to stop, and Clear Results to clear the result contents.
Wireless
Basic
To set the basic configuration for the wireless features, click Basic from the Wireless menu.