User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 2: Web Configuration
Illustrations contained in this document are for representation only. 27
To make sure that you can access the Internet successfully, please check the following first.
1. Make sure the connection (through Ethernet or USB) between the EMTA Gateway and
your computer is OK.
2. Make sure the TCP/IP protocol is set properly.
3. Subscribe to a Cable Company.
Accessing the Internet
Once your host PC is properly configured, please proceed as follows:
1. Start your web browser and type the private IP address of the EMTA Gateway on the URL
field: 192.168.0.1.
2. After connecting to the device, you will be prompted to enter username and password.
By default, the username is cablelabs and the password is admin.
If you login successfully, the main page will appear. From now on this EMTA Gateway acts as a
web server sending HTML pages/forms on your request. You can configure the settings on the
webpage and apply them to the device.
Outline of Web Manager
The main screen will be shown as below.