User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 1: Connections and Setup
26
Activating the EMTA Gateway
After you install the EMTA Gateway and turn it on for the first time (and each time the modem is
reconnected to the power), it goes through several steps before it can be used. Each of these
steps is represented by a different pattern of flashing lights on the front of the modem.
Note: All indicators flash once before the initialization sequence.
If all of the lights are flashing sequentially, it means the EMTA Gateway is automatically updating
its system software. Please wait for the lights to stop flashing. You cannot use your modem
during this time. Do not remove the power supply or reset the EMTA Gateway during this
process.