User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 1: Connections and Setup
Illustrations contained in this document are for representation only. 7
Rear Panel
TEL1/2 & TEL2 Telephony RJ-11 connector
ETHERNET 1-4: Ethernet 10/100BaseT RJ-45 connector
USB: USB Connector
REBOOT EMTA: Reboot this EMTA Gateway
CABLE: F-Connector
Rating 100-240V: Power connector
Installing the Battery
This section provides information on installing batteries into the modem. Follow the steps
below:
1. Ensure the power cord is unplugged.
2. Remove the battery cover on the rear panel. There are two battery
compartments. You may install a single battery into either compartment.
3. Insert the battery into one of the rear battery compartments, as shown below.