User's Manual
Table Of Contents
- Introduction
- EMTA Gateway Features
- What’s on the CD-ROM
- Accessing the Diagnostics Display through the CD-ROM
- Computer Requirements
- Setting the Modem in the Stand
- Wall Mounting
- EMTA Gateway Overview
- Connecting the EMTA Gateway to a Single Computer
- Attaching the Cable TV Wire to the EMTA Gateway
- Important Connection Information
- USB Connection to One Computer
- USB Connection - Using the Installation Wizard
- USB Connection - Without Using the Installation Wizard
- Using Windows 2000 for USB Connection
- Using Windows Me for USB Connection
- Using Windows XP for USB Connection
- Ethernet Connection to One Computer
- Connecting More Than Two Computers to the EMTA Gateway
- Telephone or Fax Connection
- Activating the EMTA Gateway
- Accessing the Internet
- Status
- Wireless
- Frequently Asked Questions
- General Troubleshooting
- FCC Declaration of Conformity and Industry Canada Information
Chapter 1: Connections and Setup
4
Wall Mounting
The number of the screw: 2 pcs
Direction for wall mounting: LED panel upward.
Dimension for the screw: TBD
There are 4 slots on the underside of the EMTA that can be used for wall mounting.
Note: When wall mounting the unit, ensure that it is within reach of the power outlet.
You will need 2 suitable screws which screw diameter would be 4.4 mm to wall mount the Cable
Modem or the Battery Pack. Two different wall mount directions could be chosen for the Battery
Pack.
To do this:
1. Ensure that the wall you use is smooth, flat, dry and sturdy and use the 4 screw holes
which are 101.6 mm apart from each other.
2. Fix the screws into wall, leaving their heads 3 mm (0.12 inch) clear of the wall surface.
3. Remove any connections to the unit and locate it over the screw heads. When in line,
gently push the unit on to the wall and move it downwards to secure.