User's Manual
Table Of Contents
- Before You Use
- Features
- System Requirements
- For Ethernet Connection
- For USB Connection
- For Phone Connection
- Unpacking
- Chapter 1: Overview
- Physical Outlook
- Front Panel
- LED Indicators
- Rear Panel
- Chapter 2: Installation
- Connecting the Cable Modem to Your Computer
- Installation Procedure for Ethernet Interface
- Installation Procedure for USB Interface
- Chapter 3: Software Installation and Configuration
- USB Driver Installation
- For Windows 98/ME
- For Windows 2000/XP
- Uninstall USB Driver
- For Windows 98/ME
- For Windows 2000/XP
- Setting TCP/IP on Client PC
- For Windows 98/ME
- For Windows 2000/XP
- DHCP Server
- For Windows 98/ME
- For Windows NT/2000/XP
- For Apple Macintosh
- Renew PC IP Address
- Chapter 4: Web Configuration
- Usin4g Web-Based Manager
- Status
- Software
- Connection
- Security
- Wireless
- Basic
- Privacy
- Advanced
- Chapter 5: Access Internet through Cable Modem
- Accessing Internet
- Chapter 6: Troubleshooting
- Can I use the same cable line for TV and cable modem?
- My cable modem cannot get a solid green light on the Status LED when I connect the cable back.
- Which port of the Ethernet hub should I connect to the modem if I need to connect multiple PC to the modem?
- How do I see my IP address?
- Can I just connect the cable modem and two computers to a hub?
- I have a cable modem. How can I make it work?
- Can I switch between a notebook and PC using the same cable modem? Will there be a problem to obtain a DHCP IP address?
- Appendix: Specifications
- RF Specifications(US)
- Wireless LAN
- Network
- Security and Encryption
- Standard Compliance
- Physical Interface
- Physical Specifications
- Electrical Specifications
- Environmental Specifications
- Regulatory Approvals and Compliance
Chapter 3: Software Installation and Configuration
21
2.
If the iMac gets an invalid IP, select “Using DHCP Server” in “Configure” field. Click the “Close box” at the
upper left corner to close the “TCP/IP” window.
3.
Click the “Save” in the prompted message box.
4.
You need to wait about 2 minutes and open “TCP/IP” window to see the new TCP/IP status.
Renew PC IP Address
There is a chance that your PC does not renew its IP address after cable modem is on line and the PC cannot access
the Internet. Please follow the procedures below to renew PC’s IP address after the cable modem is on line.
1.
Click “Start“, point to “Run“, and click to open the “Run“ windows.
2.
Enter winipcfg in the “Open“ field. Click “OK“ to execute the winipcfg and show the “IP
Configuration“ window.
3.
S
elect the “Ethernet adapter“ to show the IP address. Press “Release“ and “Renew“ to get a new IP address