User Manual

Chapter 2:WEB Configuration
Illustrations contained in this document are for representation only.
47
will show its configuration status.
Device Name: By using this you can change the factory default to a name of your choice which is up to 32
characters longas like SSID.
WPS Setup AP: Here you do not need to change anything, just skip this step.
WPS Add Client: There are tw - you want.
But, the default PIN
- then the WPS Add Client option will appear as shown below.
Fig. 36
Add WPS Setup AP page will appear as shown in Fig.36
Fig. 37
And WPS Configure Status WPS Configure
Status as shown below. After successful connection the client will get IP address from AP
and then internet will be accessible.
Fig. 38