User manual DCM (Data Communication Module) 5-104348-192 DENSO CORPORATION
Installation Installed by the depot operators in the car's engine room. CAN bus connected to the vehicle computer, for data transmission and other control.
CAN bus define RF, speaker, GPS, MIC control by Android OS
DCM function instruction 1. Power supply and data transmission 2. USB port, data transmission 3. Connected to the camera module 4. LTE antenna connector 5. GPS antenna connector 6. Support WIFI communication Use for car communication. DCM will be installed in the space that is near dashboard, similar to 1D or 2D car entertainment device. DCM will connect with car computer and exchange information via CAN bus and be responsible for communicating with external system via WiFi or LTE(e.g.
This radio transmitter FCCID: H8NCDD6020 has been approved by FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. For 3G For LTE Operating temperature:-30~60 degree.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: H8NCDD6020” Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user.
