Bluetooth Modem User Manual
2003 All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of the seller. Disclaimer Information in this document is subject to change without notice. The material contained herein is supplied without representation or warranty of any kind.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Contents 1 Introduction ..................................................7 1.1 Overview........................................................................7 1.2 Features ........................................................................7 1.3 Package Contents .........................................................7 1.4 Minimum System Requirements ....................................8 2 Bluetooth Modem Installation.......................9 2.2 Rear Panel........................................
1 Introduction 1.1 Overview Thank you for choosing Bluetooth Modem. The Bluetooth Modem allows you to connect your personal computer to the Internet without cable. This is possible because it utilizes Bluetooth technology. Bluetooth is an open specification for short-range wireless networking standard and it is a low-cost wire-replacement technology that enables connectivity among a wide variety of electronic device such as computers, mobile phones, printers, laptops, PDAs and digital cameras. 1.
Bluetooth Modem User Guide 1.
2 Bluetooth Modem Installation Bluetooth Modem is extremely practical; it does not require installation software or driver. Just plug the AC Power cord in the Bluetooth Modem and it is ready for use. For safety, make sure the telephone line is UNPLUGGED from your modem. 2.2 Rear Panel 1. Plug one end of the RJ-11 phone cord into the LINE jack on the Bluetooth Modem, and plug the other end into your phone jack on the wall. 2.
Bluetooth Modem User Guide If the Bluetooth USB Dongle cannot find the Bluetooth Modem after 1 minute press the LINK button to try again. 2.1 LED Indicators The Bluetooth Modem is equipped with three LEDs. Check the table below for more information. LEDs Color Status Description Power Green Off No power is supplied to the unit. Solid Power is connected to the unit. Off Idle. Data Green Blinking Transmitting/receiving data. O.H. Green Off Modem OFF Hook. Solid Modem ON Hook.
3 Bluetooth USB Dongle Installation 3.1 Software Installation First, install the software provided in the CD and ONLY insert the Bluetooth USB Dongle after rebooting the PC. Follow the instructions below to install the software. 1. Close all Windows programs that are running. 2. Insert the provided Software Utility CD into your CD-ROM drive. If the installation screen does not pop up, run Setup.exe from D:\Utility&Driver of the Software Utility CD where D is the drive letter. 3.
Bluetooth Modem User Guide 12 5. In the Device Information screen, enter the name of your computer in Device Name field and select whether it is Desktop or Laptop in Device Type. 6. To install the software to the default destination folder, click Next. If you are to install the software into a different folder, click Change to select another folder. Click Next to continue. 7. Click Install when the following screen appears.
3. Bluetooth USB Dongle Installation 8. Installation process can take some minutes, be patient. 9. On Windows XP, if the Driver Signature Notice appears, click OK to continue the installation.
Bluetooth Modem User Guide 10. Click Finish when the following screen appears 11. Plug your Bluetooth USB Dongle into your computer and click Yes to reboot. Note: Don’t remove the installation CD until the installation process is completely finished. Subject to your Windows OS, different situations will occur during or after the software installation. Follow these instructions to complete the installation.
3. Bluetooth USB Dongle Installation For Windows XP After rebooting the Windows, plug Bluetooth USB Dongle into your computer. The PnP wizard will appear as described below: 1. Windows Found New Hardware Wizard will pop up. Click Next. 2. If Windows logo compatibility message appears, click Continue Anyway. 3. Click Finish. Now you are done with the installation procedure. You should be able to find the Bluetooth Configuration icon located on the system tray and My Bluetooth Places icon the Desktop.
4 Making Internet Connection 4.1 Connecting to the Internet Before you begin, make sure the Bluetooth Modem is turned on and it’s the distance with the Bluetooth USB Dongle does not exceed 10 meters, this is the maximum range covered by the Bluetooth 1.1. Now, just follow the steps below described: 1. Double-click Bluetooth Configuration icon on the system tray. 2.
Bluetooth Modem User Guide In the related field(User name, Password, dial) enter the information provided by your Internet Service Provider and click Dial. Congratulation! You are ready to access the Internet. 4.2 Sharing Internet Connection You might want to allow other Bluetooth enabled devices such as computer or laptop to access the Internet using the same connection. Follow the instructions below to deploy your wireless personal network. Server Side 18 1.
4. Making Internet Connection 3. Click OK to finish. Client Side 1. Double-click Bluetooth Configuration icon on the system tray. 2. Select and double-click Entire Bluetooth Neighborhood. 3. Select and double-click on the computer that made the Dial-up Connection(in this case, Laptop B). 4. Double-click Network Access icon and the following screen will pop-up. Just click Connect.
Bluetooth Modem User Guide 20
5 Removing Bluetooth Software If for any reason you have to remove Bluetooth Configuration software, follow the steps below: 1. Click the Start > Settings > Control Panel. 2. Double-click Add or Remove Programs icon. 3. Select BT 500 Bluetooth Software 1.2 and click Remove. 4.Click Yes to continue the uninstallation. 5. Uninstallation process takes some minutes, be patient. 6. Uninstallation process is completed. Click Yes to reboot the computer.
6 Specification 6.1 Bluetooth USB Dongle BT 210D Power Supply Power Supply 5.0 VDC USB bus-powerd Operation Voltage 1.8V for core logic, 3.3V for RF Power Consumption Peak current in ACL data transfer 720Kbps = 55mA (T=25C) Peak current in SCO HV1 connection = 60mA Stand by current = 100uA RF Characteristics Radio Output Power 0dBm (Bluetooth Spec. 1.1 class 2 device) Receiver Sensitivity -80dBm (Single slot BER = 0.1%) Frequency Range 2402 – 2480MHz, in 2.
Bluetooth Modem User Guide 6.2 Bluetooth Modem 010 IC + V.90 Specifications are subject to change without notice General Description • • • • • • • External 5V DC power supply LED display for Power on, off-hook and data transmit Bluetooth profile support modem dial-up network Support TAM through bluetooth (E-mail station’s option) Support external case Operation distance up to 10m Support Firmware upgrade Bluetooth General Description • • • Bluetooth 1.
6. Specification • • Overall Rx Sensitivity: -80dBm (typical) -70dBm (Maximum) Output Power: (Class 2) up to 4dBm Bluetooth Data transmit • Line Rate: Asymmetric mode: 721Kbps & 57.6Kbps V.90 Modem Compatibility: • • • • • V.90 --56000,54667,53333,52000,50667,49333,48000,46667,45 333,42667,41333,40000,38667,37333,36000,34667,3333 3,32000,30667,29333,28000bps. ITU-T V.34annex --- 33600,31200 ITU-T V.34 --- 8800,26400,24000,21600,19200,16800bps ITU-T V.
Bluetooth Modem User Guide V.90 Modem Telephone Line Interface: • RJ-11 phone jack to PSTN line. V.90 Modem Receive Sensitivity: FCC/DOC JAPAN CTR21 -29 ±2 dBm -29 ±2 dBm -29 ±2 dBm V.90 Modem Transmit Level: FCC/DOC JAPAN CTR21 < -12 dBm -17±2dBm -15 ±2dBm V.90 Modem DTMF Signal Level (dBm) FCC/DOC JAPAN CTR21 Hi. G = -8 ± 1 dBm Hi. G = -8 ± 1 dBm Hi. G = - 9 ± 1 dBm Lo. G = -10 ± 1 dBm Lo. G = -10 ± 1 dBm Lo. G = -11 ± 1 Dbm V.
6.
