User Manual HDMI True Matrix 4X4 （4K@30Hz/IR/ RS232） Mode No：HDMX0015M1
INTRODUCITON Picture 1.0 front panel showing Picture 1.
Picture 1.2 IR panel showing 1．Firstly remove the plastic film in the rear board of the remote board. 2．The A, B, C, D signifies the A, B, C, D output. 3．The 1, 2, 3, 4 signifies the 1, 2, 3, 4 input. 4．Firstly press the left Letter Key,then press the right Number Key,the matched input signal and output port will be connected.
signal. First to press the symbol “ALL” key at remote,then select the input channel that you want. For example: to press the symbol “ALL” key, then press number 1 key to put the input channel 1 signal to all output port; to press the symbol “ALL” key at remote,then press the number 2 key, it can select input channel 2 signal to all output port. 6．The plastic film is strongly advised to remove it when the remote is not used for long time.
Mode No HDMX0015M1 Mode name HDMI True Matrix 4X4 Input channel HDMI port x4 Output channel HDMI port x4 RS232 interface RS232 port x1 RS232 serial communication support Resolution format 480P/720P/1080P/4K@24Hz/4K@30Hz Deep color 8/10/12Bit HDMI audio output format LPCM2.0/DTS/DOLBY-AC3…… HDMI Input cable length 2160P/AWG 26 ≤5m 1080P/AWG 26 ≤10m HDMI Output cable length 2160P/AWG 26 ≤5m 1080P/AWG 26 ≤10m HDMI transmission bandwidth 25~340MHz HDMI transmission rate 0.75~10.
RS232 Serial Port Protocol !XCOM# read the current status and return to the turn-off state; Current OUTA、OUTB、 OUTC、OUTD connected input channel port status,; OUTA、OUTB、OUTC、OUTD will be turned off or not.
!SWO1# !SWO2# !SWO3# Open OUT A Open OUT B Open OUT C !RCO1# represent OUT A On !RCO2# represent OUT B On !RCO3# represent OUT C On !SWO4# Open OUT D !RCO4# represent OUT D On !SWP0# !SWP1# Shut down Power on !RCP0# represent power off !RCP1# represent power on
