User Manual

User Manual
Report no.:
01/20
First issue date:
21/07/2020
Family: Amplifier F6
Revision
01
Page:
7/16
ASK Industries s.p.a.
C.P. 110 c/o U.P. RE2 42121 Reggio Emilia IT
ALL RIGHTS RESERVED: The whole content of this document and its annexes (data, technical parameters, drawings and any other part of it) are
propriety and/or protected by copyright. It is therefore to be considered confidential and intended exclusively for checks carried out by the relevant legal
authorities. In accordance with both art. 616 of the Italian criminal code and Italian Legislative Decree no. 196/2003, the dissemination, distribution or
copying of all or part of this documentation by any person other than the recipients or for purposes other than those intended is prohibited, unless
specifically agreed.
4. Service or Installation Manual
[TABLE 4.1]
For all models covered by this File (all mechanical variants)
Suitable place:
Refer to chapter 4.5.1
a) Press the shell into the corresponding
hole [tab. 4.i] on the outside of the
installation.
Keep pressing until you hear a “click” as
the pre-fixing system engages
b) Install the amplifier in an internal
environment, under the installation
surface; Insert the screw of the product
into the hole in the previously installed
shell.
c) Check that the product is correctly
aligned with the shell. The section of the
product that interferes with the shell has
a corresponding key profile
d) Use a screwdriver with a suitable tip to
tighten the fixing screw:
Torque = 3.5 Nm
[TABLE 4.2]
For all models covered by this File (all mechanical variants)
Exact dimensions for housing the product anchoring.
NOTE: This housing governs how well the mechanical anchoring holds, i.e. it is only ensured
if this outline is 100% correct.
Outside
Inside