User Guide

USER GUIDE XGA LCD MULTIMEDIA PROJECTOR
32
SYMPTOM SOLUTION
The whole
image appears
to be unstable
or misplaced
• If the image is scaled, press SCALE to return to
the default mode.
• Adjust the frequency and tuning settings
(instability), or the image position settings
(misalignment).
• Check that you are using a source with
compatible resolution.
• The LCD projector may be connected to a source
with a non-standard computer (or video card).
Adjust the frequency and position of the image.
Cooling fan is
not working
• Check that the Power ON/OFF switch is ON.
• If the fan does not work the LCD projector must
not be used and should be returned to your
dealer for repair.
The remote
control is not
working
• Make sure you point the remote control at the
projection screen or directly at the IR receiver
• The maximum range of the IR transmitters is 15
m/ 49 feet - Are you standing close enough?
• If the effective range of the transmitters is
significantly reduced, the remote control needs
new batteries.
The desktop
mouse is not
working
• Remember that the mouse must be connected
before the computer source is switched on.
• Are the mouse cable and mouse adapter
connections secure?
• Check the mouse driver settings on the computer
source.
• You must boot the computer after the cable has
been connected for it to recognise the mouse. If
you are unsure whether this was the case, reboot
your computer.