Service manual

Nacho Family Service Manual 54
6 To remove the lamp blower, remove the two M3x30 Phillips screws with washers that fasten the blower to
the engine assembly.
7 If you are replacing the engine, unplug the color wheel sync cable from its connector on the color wheel
ECA.
Assembly Notes
♦ Torque the M1.7x5 screws that fasten the zoom ring to the lens to 2 in-lb (.2 Nm).
♦ Torque the two M3x30 screws that fasten the lamp blower to the engine to 6 in-lb (.67 Nm).
♦ Torque the three M3x8 Plastite screws that fasten the engine to the bottom case to 4 in-lb (.42 Nm).
♦ If you are replacing the engine, make to plug the color wheel sync cable in.