Service manual

Nacho Family Service Manual 51
8 To separate the power supply and chassis, pinch the locking tabs on the plastic standoff located in middle
of the AC plug side of the ECA. Then lift the power supply off of the chassis.
9 If you need to replace either the chassis or the power supply insulator, remove the plastic standoff from the
chassis.
Assembly notes
♦ Make sure to fasten the power supply ground cable to the chassis.
♦ Torque all screws to 6 in-lbs (.67 Nm).
♦ Make sure that the lamp power cable connector is secure in its chassis mount.
CAUTION Do not reassemble the power supply assembly without the insulator.