Service manual

Nacho Family Service Manual 50
4 Lift the chassis and power supply out of the bottom.
5 If you need to replace any of the assembly components, go the next step. Otherwise, place the assembly
aside and continue to the next procedure.
6 Remove the lamp power cable connector from its mount in the chassis. To do this, pinch the locking tabs
on the connector with one hand, then withdraw the connector with the other.
7 Use a T10 driver to remove the five M3x8 machine screws that fasten the power supply to the chassis, and
the M3x8 screw that fastens the ground cable to the chassis.
NOTE The power supply remains attached to the chassis once the screws are removed.