User manual

- 48 -
Result codes:
OK n=0-3
Error Otherwise
Related S-Reg: S39
AT+MS Command
+MS Modulation select
This command selects the modulation, optionally
enables/disables Automode, and optionally
specifies the lowest and highest connection
rates.
The command format is:
AT+MS=
[<mod>][,[<automode>][,[<min_rate>][,[<ma
x_rate>]]]]
<mod> a decimal number specifying the
preferred modulation (automode
enabled), or the modulation
(automode disabled).
<automode> 0/1 Automode disabled/enabled
<min_rate> minimum rate for connection. If
lower than the actual minimum
rate for the selected modulation,
the actual lowest supported
rate will be taken.
<max_rate> maximum rate for connection. If
higher than the actual maximum
rate for the selected modulation,
the actual highest supported
rate will be taken.
Table 1 - +MS command parameters