User manual

- 46 -
modem mode
\Kn Break Control (-)
Controls the response of the modem to a break
received from DTE or a remote modem or the \Bn
command.
The behavior parameter is written to Sxx
\K0 Enter on-line command mode, no break sent
to remote modem
\K1 Clear data buffers and send break to
remote modem
\K2 Same as 0
\K3 Send break to remote modem immediately
\K4 Same as 0
* \K5 Send a break to remote modem in sequence
with transmitted data
Related S-Reg: S<basereg+x> of V.42 registers
Result codes:
OK n=0-5
Error Otherwise
\Nn Error correction operating mode
\N0 Normal (Speed buffering) - No error
correction
\N1 Direct (pass-through) 128 characters
maximum block size
\N2 Reliable (error correction) mode. The
Modem will attempt LAPM and then MNP
* \N3 Auto reliable mode. Same as \N2, but w ill fall
back to Normal
\N4 LAPM error correction mode only, hang up
upon failure.