User manual

- 33 -
Nn
*
Automode control
Enable/Disable Automode detection.
N0 Automode detection disabled. A
subsequent handshake will be conducted
according to the contents of S32.
N1 Automode enabled. A subsequent
handshake will be conducted according to
the Automode algorithm.
Result codes:
OK n=0 or 1
Error Otherwise
Related S-Reg: S31
On Returns to on-line data mode
This command is normally used to connect the
DTE back after an escape (+++) has been issued.
O0 Return to on-line data mode.
O1 Return to on-line data mode, retrain first.
Result codes:
OK n=0-1
Error Otherwise
P Pulse dialing
Forces pulse dialing. Applies to subsequent
dialing commands.
This command holds until the next T dial modifier
or T command is received.
The modem will go off hook and attempt to
answer an incoming call. Upon successful
completion of handshake, the modem will go on-
line in answer mode.