User manual

- 26 -
When using V.42bis or MNP5, some features
are disabled.
§ You may be using a non-streaming protocol,
like Xmodem or Ymodem to transfer files.
Those are fine unless you are using V.42bis
or MNP5
When using V.42bis or MNP5, you should use a
streaming transfer protocol like Ymodem-G or
Zmodem.
Configure your software to use hardware flow
control (RTS/CTS ON).
When the modem is connecting to another
modem, it reports a higher connect baud rate
that it is really using.
§ The modem defaults to report the modem-to-
computer baud rate when it responds with
CONNECT.
Go to command mode with your communication
program (like Telix) and type ATW2, then press
Enter. This tells the modem to report the modem-
to-modem baud rate instead