User manual

- 23 -
§ The remote modem is not echoing your typed
characters.
Type ATE0 then press Enter at the command
line. Then turn the software echo feature on.
§ Your software may not be set to use Full
Duplex or the remote modem may not be set
to use Full Duplex either.
§ C:The remote modem may be waiting for you
to type a command before it will reply with
text.
No text appears on the screen when in
command mode.
If you can't see the characters you are typing,
then type ATE1 then press Enter.
The modem does not dial a phone number
after you execute the AT dial command.
§ If you are using touch tone dialing on a phone
line that requires pulses, then it may not
work.
Use ATDT in place of ATDP.
When your communications software tells
the modem to dial, it does not.
§ Make sure the software dialing prefix is
ATDT.
§ Make sure the software and modem are set
to the same COMx: port.
§ The modem may not have hung up the phone
line since the last call.
Change to command mode and type ATH then
press Enter.
When dialing another modem, you receive a
'CONNECT' response, but nothing else.