User Manual

Fig. 6: SPI Plugin settings
It is possible to choose bit order (MSB first, LSB first), synchronising on rising
or falling edge (signal chip select in positive or negative logic level) and data
sampling on a rising or falling edge of clock signal.
7.3 I2C Bus Analyzer Plugin (dll_i2cbus.dll)
This plugin decodes captured I2C signal and displays start bits, stop bits,
addresses, acknowledges and data in hexadecimal values.
Fig. 7: I2C Plugin settings
Each of input signals can be choosen as SDA or SCL signal. There are two
possibilities how to display I2C address: with or without the LSB displayed
(e.g. A0/A1 device address is displayed as A0W/A1R in first case or 50W/50R
in the other).
7.4 USB Analyzer Plugin
Reading the USB specification is highly recommended before using USB
Analyzer plugin.
Instalation
USB analyzer has been drawn up as one of the plugins and it is a part of the
installation package and so there is no need to install that. For setting up the
license hit License Install New Licen→ se... in SIGMA2 main form.
Page 13 of 19