Operation Manual

26
Instr uc tion Ma nua l
AP01 : WJ32
How to Use PACE Function
PACE _LOG Mode
Log data set
to be deleted
Confirmation of whether or not the
selected data set should be deleted
Confirmation of whether or not the
entire log data should be deleted
Number of data in memory
Number of data in memory
Initial display of PACE_LOG mode
B
B B
Press for
more than
2 seconds.
Keep the button
pressed for 2 more
seconds or longer.
Keep the button
pressed for 2 mo
re
seconds or longer.
Beep,
beep,
beep
Long
beep
Release button B.
* The log data has not been deleted yet.
The newest log data
is shown.
Release button B.
To delete one log data set
* Be sure to keep button B pressed until the confirmation beep sounds. Otherwise, the log data will not be deleted.
* The entire log data can be deleted only after one log data set is deleted.
* The log data in memory can be checked or deleted in both the SPM_LOG an
d PACE_LOG modes. If any log data set is deleted in one mode, it
cannot be checked in the other, either.
* Before deleting the log data, check that the chronograph is reset.
When the number of measurement data in memory nears the capacity limit (up to 300 data can be stored), the storable number of data can be increased by deleting the log data.
To delete the entire log data
Notes on deletion of log data
Confirmation beep Confirmation beep