Operation Manual

23
Instr uc tion Ma nua l
AP01 : WJ32
How to Use PACE Function
PACE_CHR Mode (Measurement with PACE Function)
Chronograph measurement
Operate the button as shown in the illustrations below to measure lap and split
times while you are running.
CHRONOGRAPH
mark
Button B: Mode change
Button D: Selection of
measurement display
Button E: Lap/reset
Button A
: Start/stop
Start
Start Start
LAP
LAP
Stop
Stop Stop
Reset
Reset
Running is interrupted.
Measurement
is stopped.
Lap time: Time required to run any given section of the entire distance.
 (Ex.: Time required to run a circuit in a track race)
Split time: Time required to run from the start to any given point of the
entire distance (10 or 20 km point).
Changeover of displays during measurement
 When each of the displays in the upper box is selected before measurement, the display just
below it in the lower b
ox will appear, respectively, by pressing button D during measurement.
Display of lap data
 When the lap time is measured by pressing button E, corresponding lap data is displayed for 6 seconds.
Display shown by pressing the button
Display selected before measurement
* The lap data is displayed in the format above irrespective of the measurement display selected before starting the measurement.
* SP and LP shown on the left side of the display stand for split time and lap time, respectively.
SP: split time, LP: lap time
*
When the lap time or split time measured exceeds 1 hour, LP or SP will disappear, respectively.
Split time
PACE PACE Distance run PACE
Split time
Split time
SPLIT time
Current time
Lap data
Split time
Average pace of the lap
Lap time
Lap No.
Distance run
Distance run Distance run
Lap time PACE
Current time
Lap time
Lap time
Current time Lap time
Current time
SPM
SPM SPM SPM
SPLIT2
SPLIT2 SPLIT2
SPLIT1
SPLIT1
LAP1
LAP1
LAP2
LAP2 LAP2
Button C: Lighting up
backlight
A f t e r 5
seconds
A f t e r 5
seconds
A f t e r 5
seconds
A f t e r 5
seconds
󰽧 󰽧 󰽧 󰽧
󰽤
󰽤
󰽤
󰽤 󰽤 󰽤
󰽨
󰽨
󰽨
󰽨