Operation Manual
21
Instr uc tion Ma nua l
AP01 : WJ32
Button D: Selection of
type of pace to be set
Decreasing digits to be
adjusted
Button E: Selection of digits to be adjusted
Button A: Increasing
digits to be adjusted
Selection of type of pace to be adjusted Data input
How to Use SPM Function
MANUAL+ Mode
* If the chronograph is not reset, CHR_
in_Use is shown.
When the MANUAL+ mode appears, “MANUAL+” is shown in the lower row of the dis-
play for 1 second before the AVG_PACE display is shown.
SPM
PACE
Button B: Mode change
Button C: Lighting up
backlight
Button B (pressed for more
\than 2 seconds): Deletion of data
Adjustment of data set in the SET_UP mode
By following the procedure below, the data set in the SET_UP mode can be adjusted manually.
Deletion of data
Deletion of the pace data of one type affects the pace data of the other types differently depending on which type of pace data is deleted.
AVG_PACE SLOWPACE
Adjustment of pace
*
If the corresponding pace data has not been set, - - - - is shown.
*
If the data of the AVG_PACE has not been set, selection of SLOW PACE or FAST PACE display cannot be made.
Note that, if the data set for the AVG_PACE is renewed, the data set for the SLOW
PACE and FAST PACE will be initialized and cleared.
FASTPACE
Adjustment of SPM
Type of pace data to be deleted Status of pace data
AVGPACE All types of pace data is deleted.
SLOWPACE
Only the pace data of the AVG_PACE remains
undeleted.
FASTPACE
Pace data
Confirmation of whether or not the selected data should be deleted
After deletion of data
B
Press for
more than
2 seconds
*
If the input value is invalid, the error beep sounds, and INVALID is shown to indicate that the adjustment was incomplete.
*
If the input value is valid, the confirmation beep sounds, and complete is shown to indicate that the adjustment was completed properly.
Keep the
button
pressed
for 2 more
seconds or
longer.
B
Long
beep
Beep,
beep
Confirmation
beep
Error beep