Operation Manual

15
Current time
How to Use SPM Function
SPM_CHR Mode (Measurement with SPM Function)
 Chronograph measurement
Operate the button as shown in the illustrations below to measure lap and
split times while you are running.
CHRONOGRAPH
mark
Button B: Mode change
Button C: Lighting up backlight
Button D: Selection of
measurement display
Button E: Lap/reset
Button A
: Start/stop
Start
Start Start
LAP
LAP
Stop
Stop Stop
Reset
Re
set
Running is interrupted.
Measurement
is stopped.
Lap time: Time required to run any given section of the entire dis-
tance.
(Ex.: Time required to run a circuit in a track race)
Split time: Time required to run from the start to any given point of
the entire distance (10 or 20 km point).
 Changeover of displays during measurement
 When each of the displays in the upper box is selected before measurement, the display just
below it in the lower bo
x will appear, respectively, by pressing button D during measurement.
Display of lap data
 When the lap time is measured by pressing button E, corresponding lap data is displayed for 6 seconds.
Display shown by pressing the button
Display selected before measurement
* The lap data is displayed in the format above irrespective of the measurement display selected before starting the measurement.
* SP and LP shown on the left side of the display stand for split time and lap time, respectively.
SP: split time, LP: lap time
* When the lap time or split time measured exceeds 1 hour, LP or SP will disappear, respectively.
Instr uc tion Ma nua l
AP01 : WJ32
Split time
SPM SPM
SPM
SPM
Split time
Split time
Lap data
Split time
Average SPM of the lap/
Lap time
Lap No.
Split timeLap time
Lap time
Lap time
Lap time
Current time
Current time
Current time
Distance run
Distance run Distance run Distance run
After 5 seconds After 5 seconds After 5 seconds After 5 seconds
SPLIT2
SPLIT2 SPLIT2
SPLIT1
SPLIT1
LAP1
LAP1
LAP2
LAP2 LAP2
󰽤
󰽤
󰽤
󰽤 󰽤 󰽤
󰽨
󰽨
󰽨
󰽨
󰽧 󰽧 󰽧 󰽧