User's Manual

NEUTRON™ DIAGRAM
REMOTE DIAGRAM
FLYING TIPS
• It is recommended that you operate the Neutron™ in a wide space. The ideal space should have a 200
foot radius.
• Parental guidance or adult supervision is suggested at all times.
• If you are flying the Neutron™ with others, make sure all spectators are behind you.
• For best performance, it is recommended that you operate the Neutron™ in zero wind conditions.
Wind can greatly affect the performance of the Neutron™.
Important! When syncing your Neutron™ copter with the controller always make sure that the
copter is on a flat level surface and that your digital trim settings are in the center position. This
insures that the 6 Axis gyro is properly programmed to mimic your trim settings.
Your Neutron™ utilizes an automatic 2.4G channel selection system that allows up to 8 people to fly
side by side in the same wireless range with no interference.
For One Person Play:
1. Before starting, make sure that the power on both your controller and Neutron™ are in the OFF
position. Make sure that there are no other 2.4G devices in the area as well.
2. Turn ON the Neutron™ and set it down on a flat surface. The white and red LED indicators of the
Neutron™ should begin to flash.
3. Turn ON the remote, you will hear long beep, the Neutron’s white and red LED lights should change to
solid, pull the throttle all the way down. Right now your controller and the helicopter successfully
synced , Should this not happen, repeat above steps again.
For Multi Person Play:
4. Before starting, make sure that the power on all Neutrons and Controllers are in the OFF position.
Make sure that there are no other 2.4G devices in the area as well.
5. Each person will have to sync their Neutron™ individually at a different time to avoid interference.
Follow steps 1 to 3 above making sure to keep away from other people while also making sure that no
one else is syncing at the same time.
6. After syncing a player’s Neutron™, it should be left ON until all players have synced their Neutron™
copters.
7. Should there be a mistake/interference, all players must turn off their controllers and Neutron™
Quadrocopters for 60 seconds and then begin the process again.
SYNCING YOUR NEUTRON™
Power Indicator Light
Throttle Control
Speed Indicator
Lights
360˚Stunt Rolls/Speed button
Forward Trim
Backward Trim
Directional
Controls
Power On/Off
Left Banking Trim
Right Bank Trim
DO NOT FLY YOUR NEUTRON™ IN FOUL WEATHER!
WARNING
• Verify that there are 2 “AAA” batteries inside the remote control unit and the Neutron™ has been fully charged.
• Make sure your Neutron™ and controller are both turned on.
• Make sure to be in a large space with an open radius of at least 50 feet.
• Make sure the empty space has no obstacles and river. Set your Neutron™ on a clean flat surface before take-off.
DO NOT ATTEMPT TO FLY YOUR NEUTRON™ IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING
OUTDOORS. IT COULD DAMAGE YOUR PRODUCT AND POSSIBLY EVEN CAUSE BODILY HARM.
PREPARING FOR FLIGHT
3 4
F
L R
B
Safety Cage
Front Rotor Blades
(white color)
Landing Gear
Digital Camera
Rear Rotor Blades
(black color)
4 CH + Start & Stop
Video Recording Button
3 CH + Camera Snap
Shot Button
Micro SD Card
Socket
battery
compartment