Specifications Sheet

ISSUED:
REVISED:
MODEL No:
Accessory Specialties AMERICAN DISPENSER D esert R ay P roducts ,INC.
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
0141-0144
2-07
SURFACE MOUNTED SENSOR HAND AND FACE DRYER (pg 1/2)
SPECIFICATION
Surface Mounted Automatic Hand and Face Dryer shall operate automatically from IR sensor that shall activate dryer when hands
are placed in sensor zone. Motor and heating element shall have internal resetting automatic thermal protection. Cover shall be
fabricated of one-piece, heavy-duty cast aluminum 7/64" (.109", 2.8) thick, and shall have all exposed surfaces finished with acid,
chip and scratch resistant epoxy enamel. Chrome plated flip nozzle shall be heavy duty, rust proof and tamper resistant. Back
plate shall be a heavy duty, formed corrosion protected steel plate. Air intake and nozzle shall not allow access to internal
parts. Circuitry shall have fail-safe off protection to prevent hold-on. Circuitry shall have a preset start-up delay to eliminate
false triggers such as close proximity of passers-by and also a preset delay from last trigger to provide continuous drying time
as hands are moved in and out of sensor zone. Sensor shall have an adjustable triggering distance. Entire unit shall be
internally electrically grounded. Dryer unit shall have approval and be listed under the re-examination services of
Underwriters Laboratories, Inc. Unit shall be warranted against defects in materials or workmanship for ten (10) years.
Owner's Manual shall be provided with unit in carton.
Surface Mounted Sensor Hand & Face Dryer shall be Model N
o
0141 (or N
o
0144) of American Specialties Inc.,
441 Saw Mill River Road, Yonkers, NY 10701-4913 .
INSTALLATION
Unit is surface mounted on wall with four (4) 1/4" (M6) screws (supplied) through holes provided in back plate. For masonry
walls use expansion bolts or anchors for 1/4" (M6) screws. Electrical service is supplied and connected (by others) prior to
installing cover. Cover is secured to back plate with two (2) tamper-resistant lock screws (supplied) using key wrench provided.
For compliance with ADA Accessibility Guidelines, install unit so that bottom edge of dryer is 48" (1219) max. AFF. For general
utility install unit so that bottom edge of dryer is 45" to 50" (1143 to 1270) AFF. For two or more dryers, dryers should be no closer
than 24" (610) on center. Installation Template shall be provided with unit in carton.
OPERATION
Dryer is activated by user placing hands under sensor. Dryer automatically shuts off after time-out when user removes hands from
sensor zone. User manually tilts flip nozzle for face drying and holds it in position. Nozzle automatically returns to hand position
when unit turns off.
U
L
R
C
US
AMERICAN SPECIALTIES, INC.
www.americanspecialties.com
441 Saw Mill River Road, Yonkers, NY 10701 [phone]