Specifications Sheet

AMERICAN SPECIALTIES, INC.
441 Saw Mill River Road, Yonkers, NY 10701
[phone] • [phone]
www.americanspecialties.com
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
SURFACE MOUNTED SENSOR HAND DRYER (PAGE 1 OF 2)
MODEL №: 0165
ISSUED: 10/05
REVISED: 15 AUG 2016
SPECIFICATION
Surface Mounted Hand Dryer shall operate automatically from IR sensor that shall activate dryer when hands are placed in
sensor zone. Motor and heating element shall have internal resetting automatic thermal protection. Cover shall be fabricated
of one-piece, heavy-duty cast aluminum 7/64" [2.8] thick, and shall have all exposed surfaces finished with acid, chip and
scratch resistant epoxy enamel. Fixed directional air vanes shall be heavy duty, rust proof and tamper resistant. Air intake
slots shall not allow access to internal parts. Back plate shall be furnished with vibration isolating mounting bushings.
Circuitry shall have self-adjusting time-out and fail-safe off protection controlled by a microprocessor that shall detect and
reject false signals and shall automatically self-calibrate to provide uniform sensitivity over its entire life span. Entire unit
shall be internally electrically grounded. Dryer unit shall have approval and be listed under the re-examination services
of Underwriters Laboratories, Inc. Unit shall be warranted against defects in materials or workmanship for Ten (10) years.
Surface Mounted Sensor Hand Dryer shall be Model No 0165 of American Specialties Inc., 441 Saw Mill River Road,
Yonkers, NY 10701-4913
INSTALLATION
Unit is surface mounted on wall with four (4) 1/4" [6] screws, washers and bushings (supplied) through rubber grommets
(supplied) in a corrosion protected formed heavy steel back plate. For masonry walls use expansion bolts or anchors for
1/4" [6] screws. Electrical service is supplied and connected (by others) prior to installing cover. Cover is secured to back
plate with two (2) hex socket security screws (supplied). For compliance with 2010 ADA Accessibility Standards, unit
should be installed so that bottom edge of dryer is 48" [1219] maximum above finished floor (AFF). For general utility,
install unit so that bottom edge of dryer is 45" to 50" [1143 to 1270] AFF. For two or more dryers, dryers should be no closer
than 24" [610] on center.
OPERATION
Dryer is activated by user placing hands under sensor. Dryer automatically shuts off after time-out when user removes hands
from sensor zone.