Specifications Sheet

ISSUED:
REVISED:
MODEL No:
Accessory Specialties AMERICAN DISPENSER D esert R ay P roducts ,INC.
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
SURFACE MOUNTED TWIN HIDE-A-ROLL TOILET TISSUE DISPENSER
0030
AMERICAN SPECIALTIES, INC.
www.americanspecialties.com
441 Saw Mill River Road, Yonkers, NY 10701 [phone]
01-87
01-08
SPECIFICATION
Surface Mounted Twin Hide-A-Roll Toilet Tissue Dispenser shall hold and dispense two (2) standard or two (2) 5-
1/4" diameter (Ø133) 1800 sheets tissue rolls and shall have door, door frame, and dispensing mechanism fabricated
of alloy 18-8 stainless steel, type 304, 18 gauge; cabinet body shall be same grade, 22 gauge. All exposed surface
shall be N
o
4 satin finish and be protected during shipment with a PVC film easily removable after installation.
Internal mechanism levers shall be fabricated of molded high-impact resistant plastic for smooth operation. Structural
assembly of body and door components shall be of welded construction. Door hinge shall be of heavy-duty stainless
steel 3/16" diameter (Ø4.8). Door shall be held closed with a tumbler lock keyed alike to other ASI washroom
equipment. Cabinet shall include theft resistant and vandal resistant rollers that shall be of molded high-impact
resistant plastic with integral molded-in stainless steel end pins and two (2) rollers [p/n R-004] shall be supplied.
Surface Mounted Twin Hide-a-Roll Toilet Tissue Dispenser shall be Model N
o
0030 as manufactured
by American Specialties, Inc. 441 Saw Mill River Road Yonkers, New York 10701-4913
INSTALLATION
Unit is surface mounted on wall or partition using four (4) N
o
10 self-tapping screws (by others). Top two mounting
holes through back are “keyhole” slots for ease in hanging unit on pre-installed screws. Bottom two mounting holes
are horizontal slots for ease of adjustment. For compliance with ADA Accessibility Guidelines, top of unit should be
installed 29" (737 mm) above finished floor.
OPERATION
Reloading instructions are printed on graphic label inside door. Bottom roll is depleted prior to top roll
automatically dropping into lower position for use. Empty rollers can not be removed without key unlocking door.
6"
[152]
12"
[305]
2-
1
2
"
[64]
7"
[178]
3"
[76]
1-
1
2
"
[38]
PIN TUMBLER
LOCK
MOUNTING HOLES
CONCEALED ON
REAR WALL
HINGE PIVOT
3"
[76]
6-
1
2
"
[165]
11-
7
8
"
[302]
5-
3
4
"
[146]
NOTE: ALL DIMS ARE INCH [MM]