USER MANUAL TRANSPORTA.
TRANSPORTA.
CONTENTS: INTRODUCTION AND SETTING UP 1 SPECIFICATIONS AND PARTS LISTING 2 PARTS DESCRIPTION 3 OPERATING WIRELESS DEVICES - BODYPACK RECEIVER - WIRELESS MODULE DESCRIPTION - WIRELESS MICROPHONE MAIN CONTROLS - MAIN CONTROL PANEL 1 DESCRIPTION - MAIN CONTROL PANEL 2 DESCRIPTION GENERAL USAGE: - TURNING ON - ATTACHING AN MP3 DEVICE - CHARGING THE UNIT - WIRELESS MIC PRIORITY - LINE IN/LINE OUT - CHANGING THE BATTERY SAFETY INFORMATION TRANSPORTA.
INTRODUCTION: Ashton is designed in Australia by a team of industry experts that have years of experience in the development, design and production of musical instruments and equipment. Ashton’s range of instruments are a result of years of development and careful testing. Every Ashton product is designed with value in mind and features the highest quality materials available. This manual will help you understand some of the great features of your Transporta.
SPECIFICATIONS: GENERAL SPECIFICATIONS: RECEIVER SPECIFICATIONS: SPEAKER 1 X 10” Woofer & 1 x 1” Tweeter (at 4ohm) RF RANGE UHF 801- 825Mhz STABILITY ± 0.005% RECEIVER MODULE UHF PLL 16-channel truediversity single receiver DYNAMIC RANGE ± 40KHz w/level limiting circuit FREQ. BAND UHF 600 - 960 MHz (801 - 825 MHz) S/N RATIO >110dB T.H.D >105dB SQUELCH CIRCUIT Pilotone squelch/PLL synthesised receiver/Non-diversity FREQ.
PARTS DESCRIPTION: A. CARRY HANDLE B. ACCESSORIES TRAY: Storage space for mics and cords. C: WIRELESS MODULE: Turn to page 4. D. MAIN CONTROL PANEL 1: Turn to page 5. E. MICROPHONE RECHARGING BOX: Simultaneously charge up to 4 wireless mic batteries in this compartment. F. M AIN CONTROL PANEL 2: Turn to page 5. G. POWER SWITCH: Switch to turn power ON and OFF. H. AC POWER INPUT I. INTERNAL BATTERY OPERATING WIRELESS DEVICES BODYPACK RECEIVER: A. POWER SWITCH B.
OPERATING WIRELESS DEVICES WIRELESS MODULE DESCRIPTION: A. RA SIGNAL INDICATOR: Lights up when wireless RF signal is received. B. LED DISPLAY: Displays selected channel, to change use D. C: AF SIGNAL INDICATOR: Lights up when microphone audio signal is received. D: CHANNEL SELECTOR BUTTONS: Turn to set wireless channel (up to 16). E. RB SIGNAL INDICATOR: Lights up when wireless RF signal is received. F. P OWER LED: LED power indicator. G.
MAIN CONTROLS PANEL 1 DESCRIPTION: A / B. CD/TAPE VOLUME KNOBS: These knobs are only used when tape deck or CD player is installed. C: LINE IN VOLUME KNOB & JACK: Volume control for external audio input. Connect external audio (eg, MP3 or stereo). Level controlled by C. D: RCA LINE IN: Plug an RCA device (eg, MP3 or stereo) via this input. E. E CHO LEVEL KNOB: Controls the level of echo (delay) on both the wireless and wired mics. F.
GENERAL USAGE TURNING UNIT ON: When turning the unit on always make sure all the volume knobs are set to minimum and unplug any attached devices. This will ensure longer speaker life. ATTACHING AN MP3 DEVICE: The best method for connecting an MP3 device to the Transporta is via the RCA inputs located on the main panel (see panel description on previous page). By using this input you ensure that both the left and right stereo signals are heard through the device.
GENERAL USAGE CHANGING THE BATTERY: 1. Switch off power to device before changing the batteries. 2. Take out screws on battery plate located on back panel (see diagram). 3. Take batteries out. 4. Match the pole with colour of the battery and it’s subsequent slot and replace batteries. - Page 7 - TRANSPORTA.
SAFETY INFORMATION: INSTRUCTIONS RELATING TO RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. WARNING! When using any electronic product, basic precautions should always be followed, including the following: 1. Read all the safety and installation instructions and explanations of graphic symbols and set-up/controls before using the products. 2. This product must be earthed.
info@ashtonmusic.com.au TRANSPORTA.
