Specifications

Command/Response Formats 77
Commands
ALT: Set Ellipsoid Height
$PASHS,ALT,f
Sets the ellipsoidal height of the antenna, where f = ±99999.999 meters. The receiver
uses this data in the position calculation for 2-D position computation, and when in
differential base mode.
Examples: Set the ellipsoidal height of the antenna to 100.25 meters.
$PASHS,ALT,100.25 <enter>
Set the ellipsoidal height of the antenna to -30.1m.
$PASHS,ALT,-30.1 <enter>
ANA: Post-Survey Antenna Height
$PASHS,ANA,f
Sets the antenna height after survey, where f is from 0.0 - 64.0000 meters. This
command is used to record the antenna height after a survey, as a check to verify the
original antenna height.
Example: Set the after survey antenna height to 3.5343 meters.
$PASHS,ANA,3.5343 <enter>
ANH: Set Antenna Height
$PASHS,ANH,f
Sets the antenna height where f is from 0.0 - 64.0000 meters.
Example: Sets antenna height to 3.534 meters.
$PASHS,ANH,3.534 <
ENTER>
ANR: Set Antenna Reduction Mode
$PASHS,ANR,s
Sets the antenna reduction mode. The mode selection is used to translate between
ground mark position and antenna phase center position.
When turned on, this mode applies the antenna parameters entered via $PASHS,ANT
to the computed position to make it the ground mark position. This implies that the
base position entered should also be the ground mark position of the base.