Specifications

164 Z-Family Technical Reference Manual
where each item is as described in Table 6.96 on page 164.
GXP: Horizontal Position Message
$PASHS,NME,GXP,c,s
This command enables/disables the horizontal position message where c is either A,
B, C, or D, and s is ON or OFF. If no position is computed, this message is output but
the positon related fields will be empty.
Example: Output GXP message on port C
$PASHS,NME,GXP,C,ON <enter>
Table 6.96: Typical GSV Message
Item Significance
2 Total number of messages 1..3
1 message number 1..3
8 number of SVs in view 1..12
16 PRN of first satellite 1..32
23 elevation of first satellite 0..90
293 azimuth of first satellite 0...359
50.3 signal-to-noise of first satellite
19 PRN of second satellite
63 elevation of second satellite
050 azimuth of second satellite
52.1 signal-to-noise of second satellite
28 PRN of third satellite
11 elevation of third satellite
038 azimuth of third satellite
51.5 signal-to-noise of third satellite
29 PRN of fourth satellite
14 elevation of fourth satellite
145 azimuth of fourth satellite
50.9 signal-to-noise of fourth satellite
*78 message checksum in hexadecimal